...
Agitator Temperature Sensors - Wiring Diagram:
...
Software Actions
...
Action
...
Notes
...
Turn on motor
...
Will occur just before start of spectrometer exposure.
...
Turn off motor
...
Will occur during readout of spectrometer exposure.
...
Read temperature values
...
Two sensors attached to Analog Inputs
Operational Modes
Link to Agitator tab within Operational Modes Spreadsheet
Required Adjustable Settings
...
Setting
...
When Needed
...
Notes
...
Build
...
Observing
...
Maintenance
...
Motor speed
...
YES
...
NO
...
MAYBE
Required Telemetry
...
Parameter
...
Report Frequency
...
Purpose
...
Notes
...
Motor RPM
...
once per minute (TBC)
...
Ensures agitator is running properly
...
When the encoder is mounted on the motor, it rotates in the same direction as the motor.
In the final design of the agitator, the encoder will be removed from the motor. It will be installed on a separate shaft that will rotate in the opposite direction of the motor.
Noted here as the Galil-related software might need to address this internally.
...
Motor current
...
once per minute (TBC)
...
Ensures agitator is running properly
Higher motor current could indicate wear or snags
Suggestion from Galil (email to SG):
“You can monitor the commanded current via the Tell Torque command (TT). This monitors the commanded torque or motor command signal that we are sending to the amplifier. This signal is a -10V to +10V signal. Using this with the amplifier gain (AG command) you can find what the command current is.
...
Relevant Datasheets & Manuals
Description | File | Source | |||||
|---|---|---|---|---|---|---|---|
| 1 | Galil DMC-3x01x Datasheet |
| http://www.galilmc.com/motion-controllers/single-axis/dmc-3x01x#info=0 | ||||
| 2 | Galil DMC-30000 Manual |
| |||||
| 3 | Temperature Sensors |
|
...