Content Comparison

Ion Pump Controllers

4

Gamma¹

SPC-1-P-S-1-US110-E-S-N

Ion Pumps

4

Gamma¹

3SDI1V5KNN (3S TiTan)

HV Cables [Air]

4

Gamma¹

10K-SC10-10K (10 m)

High Voltage Vacuum Feedthrough

2

Gamma¹

HV Cables [Vacuum]

4

Gamma¹

10K-TF3-5K (PTFE 3m long)

Set IP Address

Press the ‘OK’ button to open the menu dialog:

Use the right arrow to go to the ‘Ethnt’ option:

Choose the ‘Addr’ setting:

Then:

• make sure that DHCP is ‘Disabled’.

• set the IP address as appropriate (bottom four rows of this table):
  https://keckobservatory.atlassian.net/wiki/spaces/KPFElectronics/pages/1511915791/IP+Address+Assignments#Aux-Rack

Then go to the ‘Mask’ setting in the ‘Ethnt’ menu:

The subnet mask should be set to 255.255.255.0.

Then go to the ‘Gatewy’ setting in the ‘Ethnt’ menu:

The gateway should be set to 192.168.23.1.

(A gateway isn’t used by the KPF Private Network, but setting a value here just in case the device needs one).

Enable the high pressure -resolution mode for reporting pressures (this is a front-panel-only setting).

Set IP Address