Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Table of Contents:

Table of Contents

...

Introduction

...

The flat field fiber system (also known as the “wide flat” system) is used to project broadband light onto the main spectrometer CCDs. The projected light consists of a series of bands (one per echelle diffraction order), with each band being wider in cross-dispersion than the five orderlets from the Science, Sky and Simultaneous Cal fibers. This allows one to flat field and calibrate the response of pixels both within the orderlets, and also between and outside of the orderlets (which are normally not illuminated).

The system consists of a broadband source, a shutter, and a filter wheel (or in this case an aperture wheel). The aperture wheel is populated with various apertures, which are used to change the f/# of the beam leaving the output fiber (as shown below). This in turn changes the width of the bands in cross-dispersion on the main spectrometer CCDs and allows one to adjust the band overlap.

Note that a shutter is included to set the wide flat image exposure times.

Within the aperture wheel there is also a blank port, which allows no light to pass. This should be in-beam whenever the wide flat system is not in use, to prevent accidental stray light entering the main spectrometer vacuum chamber.

...

Relevant Devices

Descriptions

Qty

Source

Part Number

Notes

Filter Wheel

2

Thorlabs

FW102C

RS-232 connectivity

RS-232 to Ethernet Adapter

1

Lantronix

UDS2100

This is the version with two serial ports (and standard 9-pin RS-232 connectors)

Smaller Footprint Power Supply for Lantronix

1

Tri-Mag, LLC

Tri-Mag PN: L6R12H-120

DigiKey PN: 364-1264-ND

The stock Lantronix power supplies do not work well with the PDUs (as they block two extra outlets). KPF uses these replacement supplies since they only take up one PDU outlet.

Broadband Source

1

Thorlabs

SLS201L

See Broadband Calibration Sources

Shutter Controller

1

Uniblitz

VED24

Shutter

1

Uniblitz

DSS25B1T0

25mm Optical Shutter

Bi-stable (only requires power for transitions)

Ordering options:

Image Added

...

Relevant Functional Block Diagrams

...

& Cable Details

...

...

-to-Calibration-Unit-Interconnects

DB9 Right-angle M-F Adapter

1

Premium DB9 right angle male to female Adapter alt orientation
L-Com PN: DG909MF2-P

Allows for a strain-relief loop on the serial cable within the Flat Field Fiber enclosure.

...

Cable

Qty

Details

Notes

EthernetFlat Field Fiber Shutter

1

Cat6 Copper Ethernet Cable M-M, 6 feet long

Entirely within Cal Rack.

...

See Aux Rack External Cables

Uniblitz-Supplied 510F Cable

1

Ships with Uniblitz VED24 Shutter Controller

Uniblitz-Supplied 5M203D Cable

1

Ships with Uniblitz VED24 Shutter Controller

...

Cable

Qty

Details

Notes

Input Fiber

1

Thorlabs Custom Patch Cable
Fiber: FT1000EMT (0.39 NA; 400 – 2200 nm; 1000 um core)
Tubing: FT05SS (5mm diameter stainless steel tubing)
End 1: SMA
End 2: SMA
Length: 1 m

These were ordered using the Thorlabs custom fiber builder online: https://www.thorlabs.com/newgrouppage9.cfm?objectgroup_id=2410

Output Fiber

1

Thorlabs Custom Patch Cable
Fiber: FT800EMT (0.39 NA; 400 – 2200 nm; 800 um core)
Tubing: FT05SS (5mm diameter stainless steel tubing)
End 1: SMA
End 2: SMA
Length: 20 m

SMA-SMA Adapter

2

Thorlabs ADASMAV - Vacuum-Compatible SMA to SMA Mating Sleeve

One needed on external (air) side of flange, one needed on internal (vacuum) side

Vacuum Fiber

1

View file
nameTQ0425345.pdf

A 5m-long custom version of the standard 1m Thorlabs MV64L1.

Not This internal (vacuum) fiber is not shown on the diagram but included here for reference. This fiber carries light between the feedthrough above and the flat field fiber lens above the reformatter.

...

Pictures of Devices

...

Look-up Table for Filter Wheel Aperture Positions

...

Description

File

Source

1

Device Manual

View file
nameFW102C-Manual.pdf

https://www.thorlabs.us/newgrouppage9.cfm?objectgroup_id=988&pn=FW102C#2926

2

Software Manual

View file
nameFW102C-SoftwareManual.pdf

https://www.thorlabs.us/newgrouppage9.cfm?objectgroup_id=988&pn=FW102C#2926

3

SDK

View file
nameAppNotes_FW102C.zip

https://www.thorlabs.us/software_pages/viewsoftwarepage.cfm?code=FW102C

4

Lantronix UDS 2100 Quick Start Guide

View file
nameUDS2100_QS.pdf

https://www.lantronix.com/products/uds2100/#tab-docs-downloads

5

Lantronix UDS 2100 User Guide

View file
nameUDS2100_UG.pdf

https://www.lantronix.com/products/uds2100/#tab-docs-downlo

6

Smaller Footprint Power Supply Datasheet

View file
nameL6R12H_Series_2021-01-1.pdf

https://www.tri-mag.com/wp-content/uploads/2021/05/L6R12H_Series_2021-01.pdf

(Linked off the DigiKey product page)

7

Uniblitz VED24 Controller Datasheet

View file
nameVED24 Datasheet.pdf

https://www.uniblitz.com/products/ved24-shutter-driver/

8

Uniblitz VED24 Controller Manual

View file
nameVED24-User-Manual-1.42_Rev_C.pdf

9

Uniblitz DSS25B Shutter Datasheet

View file
nameuniblitz-dss25b-datasheet.pdf

https://www.uniblitz.com/products/dss25b/

10

Uniblitz DSS25B Shutter Solid Model

View file
namedss25b-3d-outline-model.zip