/
Exposure Meter Detector

Exposure Meter Detector


Table of Contents:


Introduction

The KPF Exposure Meter is a small prism-based spectrometer with a resolving power of ~100. The detector, described here, is an SBIG Aluma 47-10.

KPF Exposure Meter (SSL installation with only one fiber installed).

Relevant Devices

Description

Qty

Source

Part Number

Description

Qty

Source

Part Number

Exposure Meter Detector

1

Diffraction Limited (SBIG)

Aluma 47-10

Detector Power Supply

1

Diffraction Limited (SBIG)

60014A (ships with Aluma)


Relevant Functional Block Diagram

 


Cable Details

Cable

Qty

Details

Notes

Cable

Qty

Details

Notes

USB

1

USB A Male to Mini B 5 pin Male cable, 15 feet
SBIG PN 68006

Ships with Aluma

Detector Power Extension Cable

1

SBIG PN 68007

Ships with Aluma


Pictures of Devices

The Exposure Meter sits within an enclosure above the Calibration Bench on a grey 80/20 frame.
The Aluma 47-10 detector installed in the Exposure Meter. Note this picture was taken at SSL and the cable routing does not match the Keck installation.
The Exposure Meter cable routing from the Keck installation (seen inside the enclosure). The detector power and USB cables are at left, the two optical fibers are at center, and the Exposure Meter back-illumination LED power cable is at right.
Octagon end of the Calibration Unit. Yellow wires are the temperature sensors. In this view, the black Exposure Meter power cable is attached to the bottom right corner of the grey 80/20 frame.

Relevant Datasheets & Manuals

Description

File

Source

Description

File

Source

1

Aluma User’s Manual

https://diffractionlimited.com/product/sbig-aluma-47-ccd10/

2

Aluma Datasheet

https://diffractionlimited.com/product/sbig-aluma-47-ccd10/

3

Various documents that shipped with our actual KPF detector

 

 


Relevant Software

Description

File

Source

Description

File

Source

1

SBIG Linux SDK Online Manual

DLAPI: DLAPI Software Development Kit  

 

Related content