/
Network Switches

Network Switches


Table of Contents:


Introduction

As shown in the Network Diagram, the layout philosophy was to have a network switch at each location to act as a ‘manifold’ for all of the ethernet devices at that location. This simplifies the cabling between locations as then there is only a single ethernet cable connecting each location to the KPF Main Switch.

Regardless of the number of devices at each location, 24-port switches were used throughout to simplify ordering, sparing, and maintenance/replacement.


Relevant Devices

Description

Qty

Source

Part Number

Description

Qty

Source

Part Number

Network Switches

6

Aruba/HP

HP-2530-24G

Fiber Ethernet SFP Adapters

2

Aruba/HP

Note the Archon fiber ethernet cables require an ‘SFP’ adapter to be inserted into two of the SFP ports on the KPF Main Switch. We tried generic SFP adapters at first but the Aruba 2530-24G switch would not recognize them. In the end we had to go with the (more expensive) Aruba/HPE adapter “Aruba 1G SFP LC SX 500m OM2 MMF Transceiver”, HPE Part# J4858D.

Note the SoCal system uses a different switch as described here: SoCal


Relevant Datasheets & Manuals

Description

File

Source

Description

File

Source

1

2530 Series Datasheet

https://www.arubanetworks.com/products/networking/switches/2530-series/

 

2

Basic Operations Guide for Switches with our Firmware Version.

https://support.hpe.com/connect/s/product?language=en_US&ismnp=1&l5oid=5333803&kmpmoid=1009060825&cep=on&manualsAndGuidesFilter=66000013%2C66000034&manualsAndGuidesQuery=16.06

3

Management and Configuration Guide for Switches with our Firmware Version


Installation Instructions

NOTE: the switch is by default set up for DHCP. In this state the only way to connect to the switch to change any settings is via a console cable (as described below).

Once the switch has a static IP address set, you can connect to it for command-line sessions using PuTTy (using its static IP on port 22).

Description

File

Description

File

How to set up an HP network switch with a hard-set IP address.

Allows access to the switch’s web interface by typing its IP address into a browser.

Several console examples related to SFP transceivers

 

 

Related content

Basement Ethernet Cables
Basement Ethernet Cables
More like this
IP Address Assignments
IP Address Assignments
More like this
KPF Network Device Overview
KPF Network Device Overview
More like this
Thermal Sensor Locations (Spectrometer and Hallway)
Thermal Sensor Locations (Spectrometer and Hallway)
Read with this
HIRES Readiness
HIRES Readiness
More like this
Aux Rack External Cables
Aux Rack External Cables
Read with this